**** thrown chain

Status
Not open for further replies.

dave1701

Good for 100,000 Miles
Messages
1,069
Reaction score
1
Location
MICHIGAN
I have a tensioning problem with my go kart, seems the **** chain fell off again. The **** engine mount is screwed up and when I tighten the bolts down it always moves it so it changes and gets bad again. The **** sprockets are not lining up perfect so the **** chain binds and does **** when I have it anything but loose. The only way I can get it tight and good is to ****ing push the **** motor over and it goes on an angle because the **** engine mount is some cheap chinese desighn. What the hell should I do?

I'm having some trouble.
 

Blazkowiez

Kart Aficionado
Messages
2,538
Reaction score
48
Location
Houston, Texas
You'll need to space the sprockets to match man. These need to line up. The best thing I can say to get a tighter chain once you have things lined up is that you can use a screwdriver to push the motor forward while tightening bolts.
 

dave1701

Good for 100,000 Miles
Messages
1,069
Reaction score
1
Location
MICHIGAN
Hey, didn't test it yet but I compleatly removed the motor from the mount and noticed there was some grass and **** under there so mabey that was the problem, it was teedering on a bunch of ****.
 

dave1701

Good for 100,000 Miles
Messages
1,069
Reaction score
1
Location
MICHIGAN
no the **** under the motor is still wasn't the problem. The sprocket is incorrectly lined up with clutch. How do I movet the sprocket out on a 1 wheel drive
 

Blazkowiez

Kart Aficionado
Messages
2,538
Reaction score
48
Location
Houston, Texas
You can space out the sprocket on the drive wheel but always make sure you accommodate the brake drum, the band should ride on the center of the drum. You may also space the clutch slightly if necessary.
 

acg23

Member
Messages
196
Reaction score
1
Location
bay area
i had the same problem you have with the motor mount. i welded a spacer behind the engine, tappd it, then threaded a bolt and it forced the engine forward. also used a plastic cap to keep it from damaging the block. it is very simple yet effective.
 

Attachments

  • PIC-0087.jpg
    PIC-0087.jpg
    55.7 KB · Views: 17
Status
Not open for further replies.
Top