tbmiller
New member
Greetings,
I just purchased a used Craftsman Edger with a Techumseh engine, a H30 I believe. It has a Lauson carb, the type with the flat bowl. I found out this morning that it is leaking gas. Investigation found that it is coming out of the throat. Went to my local repair shop and they sold me a diaphragm repair kit, of which I installed the new diaphragm, needle, seat, spring and gasket. There were some other "O" rings left, but I could not see where they went, so I just replaced what I could see. Just reinstalled the carburetor and it is still leaking.
I just started it and it started right up. However after I shut it down, I could not restart, probably because there is gas leaking out of the throat. Not even a full choke would help. Guess I will have to let it settle down and try it again.
Can anyone help me out in solving this problem?
Thanks for any advice.
Ted
I just purchased a used Craftsman Edger with a Techumseh engine, a H30 I believe. It has a Lauson carb, the type with the flat bowl. I found out this morning that it is leaking gas. Investigation found that it is coming out of the throat. Went to my local repair shop and they sold me a diaphragm repair kit, of which I installed the new diaphragm, needle, seat, spring and gasket. There were some other "O" rings left, but I could not see where they went, so I just replaced what I could see. Just reinstalled the carburetor and it is still leaking.
I just started it and it started right up. However after I shut it down, I could not restart, probably because there is gas leaking out of the throat. Not even a full choke would help. Guess I will have to let it settle down and try it again.
Can anyone help me out in solving this problem?
Thanks for any advice.
Ted