Rob711
New member
Hey this is my first real thread here so forgive me if I'm doing something wrong. Picked up a well used Yerf 3203. Worked fine for a lap around the flat neighborhood.
After it got to its new home about three hrs away (father in laws cabin) engine became hard to restart, then would run for about 30 sec and die, as if needle valve was blocked. Took it apart quick while still on engine, cleaned out jet and gas was freely flowing out needle valve. Back together now gas freely pours out air intake as well as primer bulb, this is 6.5 hp tech. Plan to remove carb, look it over on the bench and reassemble and install. If not harbor freight 212, seems like the route.
On to the belt, before using it I took off the comit 30 drive clutch cleaned it, reinstalled. Driving the cart up a hill with my self and daughter, about 240 lbs combined, it was struggling. Belt was smoking and now rubber bits/ dust all over engine. I figured belt was worn, so I will order a new one. Wife and daughter gave it a run, sounds like it's trying to start off in third gear, sounds like a lot of load, but hardly moving. Not much to this clutch as far as part go, springs seemed ok, that inner piece slides through nice after sone Emory cloth, brass bushing intact.
Could it have been from engine not getting full power due to carb issues, worn belt, or clutch problem?
Thanks
Rob
After it got to its new home about three hrs away (father in laws cabin) engine became hard to restart, then would run for about 30 sec and die, as if needle valve was blocked. Took it apart quick while still on engine, cleaned out jet and gas was freely flowing out needle valve. Back together now gas freely pours out air intake as well as primer bulb, this is 6.5 hp tech. Plan to remove carb, look it over on the bench and reassemble and install. If not harbor freight 212, seems like the route.
On to the belt, before using it I took off the comit 30 drive clutch cleaned it, reinstalled. Driving the cart up a hill with my self and daughter, about 240 lbs combined, it was struggling. Belt was smoking and now rubber bits/ dust all over engine. I figured belt was worn, so I will order a new one. Wife and daughter gave it a run, sounds like it's trying to start off in third gear, sounds like a lot of load, but hardly moving. Not much to this clutch as far as part go, springs seemed ok, that inner piece slides through nice after sone Emory cloth, brass bushing intact.
Could it have been from engine not getting full power due to carb issues, worn belt, or clutch problem?
Thanks
Rob