Short shafted Blue motor

[Pa and Corby]

Well, I went to replace the 6.5 powersport, with the GX200 Blue clone, and found out the 3/4" shaft is 1/2"shorter! But luckely, there is a 1" spacer being the driver pulley, that allows mounting it 1"closer to the engine. Now the only way I can align the driven pulley up with the driver, is to install the gear sprocket on the outside of the pulley? Has anyone done this? will there be to much pressure on the end of the shaft? HELPPPPPPPPP I took pix, not sure how to post them

 

[Russ2251]

On bottom of quick reply you will see 'Go Advanced'. Click button.
Click on paper clip (top row next to smiley face) and click 'Browse' button. Locate pic and click 'Upload' button.

 

[847]

http://www.picoodle.com/

 

[Pa and Corby]

well. heres the pix http://s294.photobucket.com/albums/mm89/TomThesing/ im showing new brass bushings in front end and header and air filter, by the way I got it started tonight, and its gonna be a screamer!

 

[Pa and Corby]

Anybody?????????/ can i put the chain sprocket on the driven pulley on the outside of the driven pulley? (away from the motor) anybody?? help

 

[jr dragster T]

Yeah you could run it like that as long as you have good jackshaft bearings.

 

[847]

yea it look like it'll work pretty decent