Louie The Lot Lizard
New member
When one posts here he should be aware that he needs to follow his own advice.
Some time back I posted that stock clone rods needed to be clearanced on the loose side. (0.004")
I just freshened my motor with 12 races on it. As the crank was showing some "egg", I got concerned about getting it too loose and set it up with 0.003" on the loose side of the egg and 0.001" on the tight side. The motor ran on the bench for 45 min. with no problem. I installed it and ran some clutch engagement tests at full power.
The new short block will be here tomorrow. It seems that the crank needed much more clearance than I provided, there just ain't no cure for stupid!
Louie (STUPID)
Some time back I posted that stock clone rods needed to be clearanced on the loose side. (0.004")
I just freshened my motor with 12 races on it. As the crank was showing some "egg", I got concerned about getting it too loose and set it up with 0.003" on the loose side of the egg and 0.001" on the tight side. The motor ran on the bench for 45 min. with no problem. I installed it and ran some clutch engagement tests at full power.
The new short block will be here tomorrow. It seems that the crank needed much more clearance than I provided, there just ain't no cure for stupid!
Louie (STUPID)