Sad Day

Status
Not open for further replies.
Messages
56
Reaction score
0
Location
Logan County Ohio
When one posts here he should be aware that he needs to follow his own advice.

Some time back I posted that stock clone rods needed to be clearanced on the loose side. (0.004")

I just freshened my motor with 12 races on it. As the crank was showing some "egg", I got concerned about getting it too loose and set it up with 0.003" on the loose side of the egg and 0.001" on the tight side. The motor ran on the bench for 45 min. with no problem. I installed it and ran some clutch engagement tests at full power.

The new short block will be here tomorrow. It seems that the crank needed much more clearance than I provided, there just ain't no cure for stupid!

Louie (STUPID)
 

KartFab

Active member
Messages
3,381
Reaction score
60
Location
Dallas, TX
Did it seize? Too much metal in the block? What happened? I watched a video from arc and he was saying that a lot of the clone cranks are slightly over spec, and need to be sanded down a little bit to get oil clearance.
 

Poboy kartman

Senior Moments Member
Messages
12,461
Reaction score
73
Location
White Settlement Texas
Grant...when you start running high rpms...you need extra clearance for oil to get in and out....(it's kinda of an unwritten rule for racing engines)....

File this under OOPS.... I can understand the reasoning...but the best laid plans of mice and men.....
 

KartFab

Active member
Messages
3,381
Reaction score
60
Location
Dallas, TX
I get that. I am just wondering what failed in order for him to get a new block. I was assuming it was the rod.
 
Status
Not open for further replies.
Top