Seventy Won
Member
- Messages
- 33
- Reaction score
- 16
Tear down on my Ken Bar cart is complete and I've found a couple bad bearings on the jack shaft.
Two questions:
1. Does this shaft look worn to you?
2: How do I remove it? Is this just pressed on?
I have a 30 ton shop press but there appears to be a threaded portion at the rear of it. I've done a lot of Googling and You-Tubing on the subject but am still a bit unclear as to how to remove/replace this. Thanks.
Two questions:
1. Does this shaft look worn to you?
2: How do I remove it? Is this just pressed on?
I have a 30 ton shop press but there appears to be a threaded portion at the rear of it. I've done a lot of Googling and You-Tubing on the subject but am still a bit unclear as to how to remove/replace this. Thanks.