Relying on valve float as a limiter?

Status
Not open for further replies.

Badot

New member
Messages
677
Reaction score
2
So I decided that I may want to remove the governor on my trike (Greyhound 6.5) and possibly regear it for more low end torque (or maybe just leave the gearing for a theoretical 55 at 5000?)

Anyways, since I drift this thing through almost every corner, I was looking for some way to govern the engine at a higher RPM so I don't over-rev it when the wheels start sliding, but as far as valve float goes I've heard people say everything from it being perfectly safe to the piston smashing the valves and the carb blowing off... any thoughts?

Or am I just being stupid and missing an obvious way to adjust the governor to cut at maybe 5000ish (probably closer to the upper 4000s) revs? I haven't had one apart yet, but I prefer knowing what I'm doing before tearing things down and possibly breaking something.
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
i took the governor out of a clone before and it never ran except for idle on choke. have you tried unscrewing the throttle stop a little first?
 

Badot

New member
Messages
677
Reaction score
2
i took the governor out of a clone before and it never ran except for idle on choke. have you tried unscrewing the throttle stop a little first?

What throttle stop? :D

EDIT: Russ, just to clarify, are you saying it should be fine?
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
your connecting rod going right through the side of the block.......

or a flywheel explosion but that is still myth.
 

karl

Well-known member
Messages
2,449
Reaction score
719
Location
North east Ohio
I had a pushrod on a briggs ohv lawn mower engine go through the block-head. But on a go-kart no governor is ok because the engine is under more load and you can control the throttle alot better.
 

Clayton

New member
Messages
294
Reaction score
0
Location
Saskatchewan, Canada
I bypassed the gov on my clone, it works great, I would feel safer doing it on a Briggs flathead, but I think that if you aren't revving the piss out of it you will be okay.
 
Status
Not open for further replies.
Top