Quick Bits

[Master Hack]

l have the ability to machine that taper to a straight shaft and cut a keyway.

just curious, turn it 3/4? 1.0? .843?

Easy Isn't always the right decision, but an adaptor vs. tearing the motor down and removing the crankshaft. I know you know this, but just saying.

no tear down, start it up and use the angle grinder!

 

[Grizzlymi]

Even Mo' better! Gas powered lathe!

 

[Whitetrashrocker]

I would at least open it up and look inside.
He supposedly took the heads off too. Who knows what was wrong.

 

[Edwin Spangler]

Im not buying another damned one-time-use puller. I have at least 10 that have only been used once!

-And I already have a solution to the problem you may or may not see...

 

[Edwin Spangler]

Goteem

 

[ezcome-ezgo]

You win

 

[Whitetrashrocker]

Hey Grey beards.

Made me a Miller C-3826 mopar gauge testor.

10, 23, 74 ohm resistors.

Should make the gauges read low, mid, and high scale.

What'd ya think.





Ill make you one for $49.95 and a case o beer.
Send checks to middle of nowhere.
Please be advised im 2 weeks from anywhere so shipping will be 4-6 weeks accordingly.

 

[ezcome-ezgo]

Does it work?

 

[Whitetrashrocker]

Does it work?

Haven't tried it yet. Ill report back.