Whitetrashrocker
Inmate #952016
Im sure you know this.
The spacing between the bolts (red) should be the same for both sides and at the same angle, parallel.
Same for your control arms. And CV shaft. (Blue).
Your CV knuckles should be aligned with the red line.
Flip your hub contraption so the axle line is dropped if you can. Lower the tire for greater ground clearance.
Nice work though. Suspension geometry can be tricky.

The spacing between the bolts (red) should be the same for both sides and at the same angle, parallel.
Same for your control arms. And CV shaft. (Blue).
Your CV knuckles should be aligned with the red line.
Flip your hub contraption so the axle line is dropped if you can. Lower the tire for greater ground clearance.
Nice work though. Suspension geometry can be tricky.





