Project Stoopid!

Master Hack

Well-known member
Messages
3,680
Reaction score
5,832
Location
Mountain top Labratory
I have a metric shyt ton of aluminum sheet. Time to use it, and now a place as well.
I am anticipating an abundance of heat round them parts. A new ECM is beyond $500 somewhere. I'm betting heat might be an enemy. Yeah I got nuthin bedder to do anyway. Its too cold outside...
The shop is a balmy 51F after burning the wood stove all day.
 

Grizzlymi

Wolverine
Messages
848
Reaction score
552
Location
Michigan
Been getting down to the 30's here, already using the propane 2 burner heater in my 1/4 of the way insulated garage. Iv'e been keeping my eyes out for a good deal on a wood burning stove, but my cheap *** hasn't found one yet. I have plenty of chopped and stacked wood to boot! :ROFLMAO:
 

Master Hack

Well-known member
Messages
3,680
Reaction score
5,832
Location
Mountain top Labratory
Get an old 'letric water heater tank a sawzall and get after it.
ya probably shouldnt tell yer insurance guy.
make a waste oil burner. There is some serious heat free and ya don't havta get all sweaty and dirty cutting and stackin it.
 

Denny

Canned Monster
Messages
11,054
Reaction score
7,353
Location
Mayberry, Indiana
I had a waste oil furnace in my shop. 80’X 54’. 12’ walls and would keep it sunny and 70 up to -20* on 15 gallons of oil a day. Just don’t mix cooking oil with engine oil, it turns solid!
 

Master Hack

Well-known member
Messages
3,680
Reaction score
5,832
Location
Mountain top Labratory
So, l played around with fuel system component. Did l mention i scored a fuel pump and cartridge fuel filter! Neighbor and gearheah thought it would be a good trade some machining l did fer him. He got the short end of that deal!
l'm finding out there is not an abundance of space to put all this stuff. Here what l got so far. All fuel components behind a firewall, driver on the other side.

IMG_5202.jpeg
 
Top