Lefturns75
New member
Ok guys, maybe I am being too careful but I would like your opinion. I have a engine project I have been doing on and off and at times I will put the parts in a box and store them on a shelf until I start again. As I pulled the box off the shelf, I had forgotten I placed the crankshaft there and it made its way to the floor with a clang. It was wrapped in a shop towel and I have inspected it and found no dings, scratches and can't tell how it landed. My question is, would you use it or just get another?? It looks fine but it was about a 6 foot drop. If this was just a turd motor build, I figure I would use it but this one has lots of aftermarket parts in it. What's your opinion guys??
It only needs to be bent a few thousandths of an inch to really screw things up. This is just 30 some odd years experience building engines talking.