Predator 670cc and/or comet duster 94C problem(s)

Status
Not open for further replies.

FabricaTim

New member
Messages
56
Reaction score
0
Location
Phoenix, AZ
I have the predator 670cc and it didn't seem like it's getting full power. The comet duster 94c does not engage fully. I am seeing a little bit of grey smoke from the muffler. The belt only makes it about half way up the sheave. My Duster is using the pink spring with 6 pucks and the driven clutch spring is in the first hole. Also I didn't research like I should of but is my setup OK? Comet Duster 94C on the 670cc 22hp Predator? Please let me know if my setup is ok or not! Any help would be much appreciated. Thank you.
 

Attachments

  • image.jpg
    image.jpg
    241.4 KB · Views: 10
Last edited by a moderator:

KartFab

Active member
Messages
3,381
Reaction score
60
Location
Dallas, TX
The 94C was meant for snowmobiles (im thinking 2 stroke high rpm?). But it can be adjusted for a lower engagement RPM.

Did you replace original pucks? The heavier the pucks, the lower the rpm engagement will be, and the more outward force to make the drive unit engage and overcome the driven units spring tension.

http://www.vintagesnow.com/Clutch_files/comet 102C and 94C.pdf

part number 206515A for pucks would be the ones that are the heaviest for lowest rpm engagement, pulled this from the manual and it shows the slightly lighter pucks used for 4 strokes (briggs/tecumseh etc)

DRIVE UNIT should have something like this?
206095A 94C
pucks #206514A
pink spring #205858A.
1 3/16" width belt
The manual refers to the "94C Calibration Guide http://www.geminikarts.co.uk/files/comet-94cdustercalibrationguide.pdf" might want to do some digging for that. Another page about tuning it: http://kawicat.tripod.com/weblog/id4.html
couldnt find tuning guide, but here is a website that sells it WITH THE TUNING GUIDE so you could ask the owner of the site to maybe scan it and send it to you https://www.denniskirk.com/comet/94...tch-with-6-pucks-212629a.p38185.prd/38185.sku

Also could be driven units spring tension, and/or center to center distance.

If the problem is the engine (which i dont think it is unless u messwed with it) see if you can rev it to 3600 rpms under no load, then put the belt back on, and put the go kart on blocks and see if it fully engages then. If it fully engages then, you know its not the belt. It could be a belt that is too large for the center to center?

So
puck weight problem?
belt width/diameter problem?
driven unit spring tension problem?

Could be other stuff, but id look into that first
 
Status
Not open for further replies.
Top