Predator 420cc won't fire

Status
Not open for further replies.

Brandon1023

needs an oil change
Messages
422
Reaction score
4
Location
Miami, Florida, Dade County 305
[SOLVED]Predator 420cc won't fire

My beloved Predator 420 isn't working at the moment and I'm trying to narrow it down. This what happened. I repaired a generator for someone and took my carb to put it on there. So my replacement gx390 carb came in the mail and I went to put it on. I realized I put the black intake spacer on the generator, and took his old one off which had a choke hose. I broke the nozzle off and poured liquid solder in to the hole. Then I made new gaskets painstakingly, and put it all together.



I had removed the starter motor for other reasons and didn't have it assembled. I found the black wire going up to where th underside of the gas tank is, so I'm assuming this is the wire to the coil. I made sure it wasn't grounded, and went to start the engine. To my surprise, it didn't fire at the very least, let alone crank right up like it always does. So I checked for spark and it was strong. I've tried everything from Xylene to Carb Cleaner to get it to fire, but nothing happened. I tried doubling up on gaskets, and making sure the intake bolts are tight, and finally , I spent all morning putting the starter back together. I didn't connect anything to the solenoid, and used a 12v charger to connect directly to the motor. The motor spun the engine with no success. Tomorrow, when I go to the repair shop for something else, I'll ask them as well. Is it possible the solenoid is preventing the engine from firing, even though there is a spark when I pull the plug out?

Thanks for any advice.
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
If you have tested it with fuel or combustable liquid down the spark plug hole then it is probably a spark issue.
 

Brandon1023

needs an oil change
Messages
422
Reaction score
4
Location
Miami, Florida, Dade County 305
I haven't thought of giving the chamber a shot of carb cleaner. I shall try that tomorrow. I can't see why it wouldn't start.

If it fails, I'll get some long wire and run it from the key box on the kart to the engine in the middle of my garage. Got lazy and didn't feel like running them all. Although, afterfter seeing the spark and keeping the black wire to the coil from touching anything, I am puzzled. This is the only modifying done to the engine and has about 15 hours on it max.

Edit: I should add.. I am looking at a forum thread with a similar problem. I'm fearing my flywheel key may be sheered from (perhaps) the incorrect installation of the starter gears within the engine. As I had it cranking with the starter, I heard a snapping sound. I will look more in to this in the later hours of the morning. >.<
 

Brandon1023

needs an oil change
Messages
422
Reaction score
4
Location
Miami, Florida, Dade County 305
took all the prts off this afternoon including the flywheel (pretty heavy on these engines btw. I can't imagine it spinning thousands of time per minute.) And the key was fine. There is a coil and 4 magnets inside the flywheel, on the back. What does this do? It runs to the ignition box. Tomorrow, ill connect all the wires incase there s some kinda relay, even though I saw the spark.
 
Status
Not open for further replies.
Top