Brandon1023
needs an oil change
[SOLVED]Predator 420cc won't fire
My beloved Predator 420 isn't working at the moment and I'm trying to narrow it down. This what happened. I repaired a generator for someone and took my carb to put it on there. So my replacement gx390 carb came in the mail and I went to put it on. I realized I put the black intake spacer on the generator, and took his old one off which had a choke hose. I broke the nozzle off and poured liquid solder in to the hole. Then I made new gaskets painstakingly, and put it all together.
I had removed the starter motor for other reasons and didn't have it assembled. I found the black wire going up to where th underside of the gas tank is, so I'm assuming this is the wire to the coil. I made sure it wasn't grounded, and went to start the engine. To my surprise, it didn't fire at the very least, let alone crank right up like it always does. So I checked for spark and it was strong. I've tried everything from Xylene to Carb Cleaner to get it to fire, but nothing happened. I tried doubling up on gaskets, and making sure the intake bolts are tight, and finally , I spent all morning putting the starter back together. I didn't connect anything to the solenoid, and used a 12v charger to connect directly to the motor. The motor spun the engine with no success. Tomorrow, when I go to the repair shop for something else, I'll ask them as well. Is it possible the solenoid is preventing the engine from firing, even though there is a spark when I pull the plug out?
Thanks for any advice.
My beloved Predator 420 isn't working at the moment and I'm trying to narrow it down. This what happened. I repaired a generator for someone and took my carb to put it on there. So my replacement gx390 carb came in the mail and I went to put it on. I realized I put the black intake spacer on the generator, and took his old one off which had a choke hose. I broke the nozzle off and poured liquid solder in to the hole. Then I made new gaskets painstakingly, and put it all together.
I had removed the starter motor for other reasons and didn't have it assembled. I found the black wire going up to where th underside of the gas tank is, so I'm assuming this is the wire to the coil. I made sure it wasn't grounded, and went to start the engine. To my surprise, it didn't fire at the very least, let alone crank right up like it always does. So I checked for spark and it was strong. I've tried everything from Xylene to Carb Cleaner to get it to fire, but nothing happened. I tried doubling up on gaskets, and making sure the intake bolts are tight, and finally , I spent all morning putting the starter back together. I didn't connect anything to the solenoid, and used a 12v charger to connect directly to the motor. The motor spun the engine with no success. Tomorrow, when I go to the repair shop for something else, I'll ask them as well. Is it possible the solenoid is preventing the engine from firing, even though there is a spark when I pull the plug out?
Thanks for any advice.