Predator 212cc Clutch Issue

Status
Not open for further replies.

trajectory7

New member
Messages
2
Reaction score
0
I currently came into possession of a 6.5hp Predator Engine mounted on a go kart designed for off road use. Initially the kart was set up with a jackshaft connecting the engine to a live axle. However the teeth on one of the sprockets melted down, causing the chain to slip. So i removed the jackshaft and remounted the engine for a direct connection from engine to axle.

Before:


After:




Now, here comes the problem. When the kart is on blocks the clutch will engage and the wheels will spin. When it's on the ground the clutch does not want to engage no matter how much the throttle is opened. Is the clutch burned out and needs to be replaced? The kart is currently geared at 10/30, which I assume is too small given size of the tires (18" rear wheels) and weight of the kart for a centrifugal clutch to handle. Can I solve the issue altogether by installing a torque converter?

I'm pretty new to go karts, and not completely there on mechanical lingo, so bear with me. Thanks for the help in getting this thing running, everyone!
 

OzFab

Well-known member
Messages
15,615
Reaction score
76
Location
Warwick Qld, Australia
Yes, the clutch is slowly dying because you're killing it...

The reason for the jackshaft was to create a desirable gear ratio, by removing it, the ratio has changed to an undesirable ratio; 3:1 on 10" tyres is too much; how do you think it would go on 18's?

With 18" tyres & a centrifugal clutch, the desired gear ratio is around 8:1

In short, either refit the J/S after replacing the damaged sprocket or invest in a torque converter & a larger axle sprocket; with a torque converter, the desired gear ratio is around 6:1...
 
Status
Not open for further replies.
Top