Ok, so my neighbor has me working on his motor scooter. It's a MP-150 M. He basically repo'd it from his grand-daughter who neglected it. Well today I disassembled the carburetor and cleaned it all out.
After re-installing the carb, it ran great! Only problem is, at around 3500 RPM, the engine wants to bog down and stall. Same deal if you open up the throttle too quickly - It'll shut off.
But if you basically open the throttle wide open at that 3000-3500 RPM mark, it'll want to bog down THEN the engine will start hauling ***, at which point it runs great until you slow down and open the throttle again, where it does the same thing.
Any tips?
TL;DR - engine wants to bog down and cut off when you open the throttle up. What do?
After re-installing the carb, it ran great! Only problem is, at around 3500 RPM, the engine wants to bog down and stall. Same deal if you open up the throttle too quickly - It'll shut off.
But if you basically open the throttle wide open at that 3000-3500 RPM mark, it'll want to bog down THEN the engine will start hauling ***, at which point it runs great until you slow down and open the throttle again, where it does the same thing.
Any tips?
TL;DR - engine wants to bog down and cut off when you open the throttle up. What do?