Need some torque converter advice...

Status
Not open for further replies.

scottbahl

New member
Messages
16
Reaction score
0
Location
Mountain View, CA
Hi all,

I just tried out my off road go kart after installing a bigger engine and a torque converter.

The problem is.... the torque converter was having trouble engaging.

When the engine was revved, the belt would slip on the torque converter pulleys and drive the kart very slowly. Occationally, the belt would seem to 'catch' on the pulleys and the kart would take off quiclkly, as it should.

The pulleys were also getting EXTREMELY hot. The idle speed is set a little too high, which causes the driver pulley to very slightly engage on the belt when the kart is still. I dont suspect that is contributing to the problem though.


Do any of you know why the belt was not properly engaging?

Here is all the information about the kart:

40 series torque converter (comet chinese knockoff)
11 HP 340cc engine, 3600 RPM max
290lbs without rider
5.5:1 reduction through sprockets
16" diameter tires



---------- Post added at 09:23 PM ---------- Previous post was at 09:22 PM ----------

Here is a link to an image of the kart:

http://imgur.com/RxLlb60

The image doesnt seem to be displaying on my original post
 

2SlickNick

American Minibikes @ FB
Messages
2,758
Reaction score
33
Location
Mesa, AZ.
Almost sound like you are using the wrong belt size. Are you sure it is correct size?
 

2SlickNick

American Minibikes @ FB
Messages
2,758
Reaction score
33
Location
Mesa, AZ.
I kind of had a similar problem today with my 1" driver. Since it does not have the brass ring, the driver and driven need to need lined up near perfectly...
If that does not solve the issue try loosing the bolt that hold the driver on the crankshaft just a hair. Once I did that on mine it solved my engagement issue. Just make sure locktite and lock washer on that bolt.
 
Status
Not open for further replies.
Top