M
mancodingouk
Guest
I have a Manco with a 5hp Briggs engine that is about 20 years old I reckon... and I bet its never been cleaned in that time either!
I've taken the engine off the frame and I'm in the middle of cleaning down the frame ready for some primer.
The bit I'm not so sure about tackling is how best to clean the engine. I'm not particularly mechanically minded, so I don't want to strip it down completely as I'll never get it back together. I've taken off the air filter and exhaust, and I was planning on cleaning them off in citirc acid to get rid of marks and rust etc.
How's best to clean the main body of the engine? I have some silver spray for the engine block, but I want to make sure I've used the best cleaning method before I spray it. Is it best to just pressure wash the engine? If anyone has any advice I'd appreciate it.
Thanks
I've taken the engine off the frame and I'm in the middle of cleaning down the frame ready for some primer.
The bit I'm not so sure about tackling is how best to clean the engine. I'm not particularly mechanically minded, so I don't want to strip it down completely as I'll never get it back together. I've taken off the air filter and exhaust, and I was planning on cleaning them off in citirc acid to get rid of marks and rust etc.
How's best to clean the main body of the engine? I have some silver spray for the engine block, but I want to make sure I've used the best cleaning method before I spray it. Is it best to just pressure wash the engine? If anyone has any advice I'd appreciate it.
Thanks