Need help with throttle issue

[Str8trippin]

Sounds good can't wait lol have about had it with this thing


Sent from my iPhone 5s

 

[TecumsehBuilderJDKirk]

Throttle cable hookup on Tecumseh

Here is 2 of my karts with throttle done my way.

 

[TecumsehBuilderJDKirk]

Sounds good can't wait lol have about had it with this thing


Sent from my iPhone 5s

Buy the cable set at Walmart 6.97$ in bike section use zipties cut the end of cable you dont want to use remove the cable route the housing drill small hole in pedal run the cable through mount cable housing using a cable holder or through barrel end provided. Run the housing up to the side muffler bolt, drill a small hole where the bolt went run the cable through with the housing .Drill hole in linkage plate on carb use a small screw with 2 nuts then tighten the bottom nut the tighten both against each other. Use a 14guage eyelet run the cable through then use the cablestop to take out slack
Then cut the excess cable and crimp the silver piece provided.

 

[Str8trippin]

Is there any way you can get a clearer shot of the setup. That's pretty fuzzy. Can't really see what's going on there.


Sent from my iPhone 5s