Need help with clone motor

[riverfish15]

Hi, I have HF 6.5 clone. I've removed gov and installed AGK hop up kit 2. It has a 390 carb and thottle ext with pulse.

I need to hook up the throttle. I have the kiwk-link clone throttle kit. It came with just a small pix and no directions. I can not seemed to figure out how to hook it up.

Has anyone installed this kit? Does anyonehave pictures of how it can be done. Any help would be great.


Thanks in advance,

Mark

 

[oscaryu1]

Just directly hook it up to the butterfly.

 

[riverfish15]

Because of the way the carb is moved away from the motor.
The linkage is pushing instead of pulling. Instead of opening the
throttle it is closing it. I don't know if it's the angle?

I will need to lengthen the link from the gov arm to the butterfly. But something just seems wrong.

Has anyone done this to a clone? how did you solve this problem?

 

[modelengineer]

how did you solve this problem?

Just directly hook it up to the butterfly

if it's pulling it the wrong way, put the throttle cable on the other side of the carburetor.

 

[riverfish15]

ok thanks.

 

[Jblankster]

make sure you have a shield in case that flywheel explodes on you.

 

[jr dragster T]

make sure you have a shield in case that flywheel explodes on you.

Nice kind works of encouragement. Might as well spend $100 on a Billet flywheel instead of a Billet wall. Lol

 

[Jblankster]

Nice kind works of encouragement. Might as well spend $100 on a Billet flywheel instead of a Billet wall. Lol

YES! its well worth it. aswell as a rod if your going to be ordering