My New Mini-Bike

Status
Not open for further replies.

Compnerd88

Mr. Build-Sum-Sh!t
Messages
93
Reaction score
0
Location
Greensboro, NC
Got this today for $200. Everything works great....need to tune the carb a little. I like it so far







-Logan
 

solomon

Active member
Messages
1,648
Reaction score
7
Location
ca
Yup nice deal, although if i were you i would change the engine or at least un-govern it
 

Compnerd88

Mr. Build-Sum-Sh!t
Messages
93
Reaction score
0
Location
Greensboro, NC
I'll definately un-govern the motor once I get a billet rod and flatop piston ordered

This thing is still fun although it tries to cut out if you full throttle it from a dead stop and runs a little better on half choke

Any suggestions on what the problem might be?? I've cleaned the jets and etube and the fuel bowl and it seemed to help a little but it still does it

Any ideas?

-Logan
 

Compnerd88

Mr. Build-Sum-Sh!t
Messages
93
Reaction score
0
Location
Greensboro, NC
UPDATE:

Ok so.....the carb is now jetted with a 140 e-tube, I made a velocity stack for the carb (Pic below), and just received my Billet rod, flattop piston, rings, 8* advanced timing key, 18lb valve springs and stainless steel valves. Now I gotta get it all together....











Coming together....

-Logan
 

Compnerd88

Mr. Build-Sum-Sh!t
Messages
93
Reaction score
0
Location
Greensboro, NC

02mx-5

New member
Messages
309
Reaction score
0
Location
Orange County, New York
Thats crazy that the light blew out because of higher rpms. I guess that makes sense though. Adjust the idle screw a little bit higher. Sounds like a race car, they work better at high rpms and almost die when idling
 

Compnerd88

Mr. Build-Sum-Sh!t
Messages
93
Reaction score
0
Location
Greensboro, NC
I used my GPS and my Dad used his cars speedometer and I was able to hit 39mph

The Upgrades are a MAJOR IMPROVMENT! Cam and Flywheel next

-Logan
 
Status
Not open for further replies.
Top