Manco Silver Fox B&S 6.5hp

[Edwin Spangler]

I did start my post with pictures. I get it, you would like more photos. Other people have asked for some as well. I will get more photos.

You say it looks like I have all the parts for repair. I don't have any spare parts at all.

Usually dont need to replace anything, just clean and lubricate. Maybe the brass collar.

Not sure if anyone has asked for pictures yet but yea lol... Disassemble and show us all the parts.

They can tell you with great precision any and all things you may need.

 

[Whitetrashrocker]

I know you don't have spares.
Just let's see more of what you have.
Could be something as simple as an incorrect spring or a part just not installed correctly.

As Bree says , we're here to save you time money and frustrations.

 

[Denny]

And while you are at it GET A GENUINE COMET BELT!!! Yes, they are more expensive but will save you grief. The cheap belts will kind of just melt and make the clutches do strange things. Trust me on this one!

 

[jergar4]

Here are more photos. It's piss pouring rain outside so I'm not taking anything apart today. Things I noticed though. The housing to the one on the left is able to be shaken. I assume the washer I found on the ground when it fell off was being used as a spacer to push that in.

The washer behind the nylon nut was loose on the cvt on the right.

Yesterday after I reassembled the parts that fell off and drove around the yard for 15 minutes, the belt has some stripping down the side. I'm thinking it has something to do with the washer I found on the ground.

 

[Denny]

Oh so many things I see wrong. The primary is not aligned with the secondary. It doesn’t appear to be out all the way either. Did you install the belt backwards or just use a cheap non-comet belt? Because that’s how the Chinesium yak grease and rice fiber belts look after about 1/2 hour of riding. Total junk!

 

[jergar4]

Oh so many things I see wrong. The primary is not aligned with the secondary. It doesn’t appear to be out all the way either. Did you install the belt backwards or just use a cheap non-comet belt? Because that’s how the Chinesium yak grease and rice fiber belts look after about 1/2 hour of riding. Total junk!

I'll be sure to pic up some good belts. That's just what came with it. Know of any big box stores that have them or are they online basically?

I'll do some looking around and figure out how to get the primary and secondary lined up. Thanks.

 

[Whitetrashrocker]

 

[Denny]

Look on line, one belt will cost about $45.00 or so but will outlast the others by more than 10-1. The belts only go on one way on a 30 series so don’t screw it up. Go-kart supply carries COMET belts and they have a handy chart for choosing the correct one.

 

[jergar4]

The flat washer looks like the one I found on the ground with the parts that fell off the primary. Where does it go?