Manco Intruder II Drive Components

Status
Not open for further replies.

Electritech

New member
Messages
6
Reaction score
0
Location
Michigan
I finally pulled the trigger and bought a used kart from Craiglist last week. It's a Manco Intruder II 617C. 7hp Subaru engine and 30 series torque converter. The engine runs but I was not able to test drive it due to a broken belt. Supposedly the kart was kept in a garage when not in use but the drive components are definitely showing a lack of care. It looks to me that they were running the kart without the belt cover, the pulleys are rusty and the chain has some links rusted up solid. This is going to be a Christmas present for my daughter so I want to take the time and get this running right. I've ordered a new chain and have the driven pulley taken apart. The bronze bushing is cracked so I'll be ordering a new one. I am a little concerned about the driver weight assembly wear. Also, I noticed on the driven sprocket the spring is in the #1 position. Most everything I've read recommends the spring being placed in the #2 position. So, I would appreciate any recommendations whether or not I should order a new driver weight assembly and if I should change the spring position on the driven sprocket. The kart will be used mostly off road, no big hills but open fields that are not flat by any means. Thanks in advance. I will try to post some pics, so please bear with me if they don't come through.
 

Attachments

  • image001.jpg
    image001.jpg
    52.7 KB · Views: 9
  • IMAG1296.jpg
    IMAG1296.jpg
    54.5 KB · Views: 8
  • IMAG1313.jpg
    IMAG1313.jpg
    85.3 KB · Views: 7
  • IMAG1302.jpg
    IMAG1302.jpg
    59.6 KB · Views: 6
  • IMAG1303.jpg
    IMAG1303.jpg
    67.3 KB · Views: 6

Electritech

New member
Messages
6
Reaction score
0
Location
Michigan
Hi Landuse. I've been through that thread quite a bit, I even checked out his videos on youtube. If it wasn't for that thread I probably would have just thrown a new belt on there and toasted it :thumbsup:. I'll be hitting those sprockets with a wire wheel then using some wet sand paper and polishing compound to smooth them out.
My concern about the weights was I just don't know how much wear is acceptable on that assembly. You can see in the picture where it is shiny and worn. It appears that there was a small raised area that rubs against the pulley to expand it, but there isn't much of it left to it now. The springs and pins are in good shape, so I guess after I get the whole assembly cleaned up I'll throw it on the kart and see how it performs. It's pretty easy to tear apart so after a few hours of use I'll check the wear again. As for the spring on the driven, I'll just experiment with that and see what gives us the best performance.
 
Status
Not open for further replies.
Top