Leveling go kart/axles problem

Status
Not open for further replies.

Kenpilot

New member
Messages
19
Reaction score
0
Building my first kart and I just put the rear axle on and the rear tires (front were already on) and I noticed the rear end sits about 1.5-2 inches lower then the front. Unfortunately the problem lies in where I welded on the rear bearing hangers.These are the ones I have so I am very limited as to how and where I weld them to my frame because obviously I can't lower the hangers because then the hole for the axle is sitting in the middle of the square tubing.
http://www.amazon.com/Azusa-Go-Kart-Bearing-3-Hole-Flangettes/dp/B0000AX60X

I'm thinking of getting some pillow box hangers and attaching them underneath my square tubing frame but I think that will raise the rear end higher then the front. any problems with this? or should the kart be pretty level? Or I just saw a picture of somebody that welded a seperate attachement plate on the outside of the square tubing frame, right in the middle or towards the bottom of the square tubing, which allows the axle to sit a little lower then if he had mounted them on top of the square tubing but not as low if he mounted them underneath.

http://www.google.com/imgres?q=go+k...bnh=158&tbnw=225&ndsp=15&ved=1t:429,r:0,s:176

Any suggestions would be greatly appreciated.
 

Kenpilot

New member
Messages
19
Reaction score
0
I guess I should add that ive already cut off the bearing hangers i had so I'm going to need to get new hangers regardless. Just not sure which ones I should get that will help
 

klicky96

New member
Messages
558
Reaction score
1
Location
Sandusky, Ohio
If you just want the rear to sit a little higher then just get some pillow blocks, weld you up a bracket that will fit your needs and put it together.
 

Kenpilot

New member
Messages
19
Reaction score
0
Well i wasn't really looking to have the rear raised, just figured if i was stuck with one end being slightly higher then the other, it would probably be better to have the rear higher, would it not?
 

mckutzy

Well-known member
Messages
8,353
Reaction score
113
Location
bc, canada
The rear is where the motor is right? Ya have the rear higher. It isnt going to matter all that much for this, on a compitition race Kart that might be a different matter. a couple of inches should be a problem.
With that said, make sure you now have enough chain to accommodate the new length.
 

Kenpilot

New member
Messages
19
Reaction score
0
Correct, engine is at the rear. Its not a competition kart, just a project and something to run around dirt roads and in the woods with. Thanks for the advice!
 

OzFab

Well-known member
Messages
15,615
Reaction score
76
Location
Warwick Qld, Australia
A pillow block will sit around the same height as your other hangers so you'll probably have to make up a bracket regardless.

It won't matter if your front sits a bit low, in one or two ways it actually helps a little, front sitting high could have disasterous results.

Some pics would be helpful
 

klicky96

New member
Messages
558
Reaction score
1
Location
Sandusky, Ohio
A pillow block will sit around the same height as your other hangers so you'll probably have to make up a bracket regardless.

It won't matter if your front sits a bit low, in one or two ways it actually helps a little, front sitting high could have disasterous results.

Some pics would be helpful

True, Very true. I would never run a kart with a higher front end.
 
Status
Not open for further replies.
Top