lawn boy power

karl

Well-known member
Messages
2,449
Reaction score
717
Location
North east Ohio
Just sharing an update on the bike. Runs quite well, lots of torque. 140cc duraforce. Sounds healthy
 

Attachments

  • 20241028_185518.jpg
    20241028_185518.jpg
    3.4 MB · Views: 16
  • 20241028_185358.jpg
    20241028_185358.jpg
    3.3 MB · Views: 23
  • 20241028_185335.jpg
    20241028_185335.jpg
    3.4 MB · Views: 19
  • 20241028_185348.jpg
    20241028_185348.jpg
    3.2 MB · Views: 16
  • 20241028_185220.jpg
    20241028_185220.jpg
    3.2 MB · Views: 16

karl

Well-known member
Messages
2,449
Reaction score
717
Location
North east Ohio
It does not get very hot. I wrapped it to help the motor get up to temp faster more so than protect footwear.

However I need to redirect the stinger as I reek of castor oil
 

karl

Well-known member
Messages
2,449
Reaction score
717
Location
North east Ohio
It's green
 

Attachments

  • 20241106_110005.jpg
    20241106_110005.jpg
    3.7 MB · Views: 3
  • 20241106_110046.jpg
    20241106_110046.jpg
    4 MB · Views: 3
  • 20241106_110021.jpg
    20241106_110021.jpg
    2.4 MB · Views: 3

Denny

Canned Monster
Messages
11,910
Reaction score
8,404
Location
Mayberry, Indiana
I don’t think Bob is going to like your head tube. It took him 6 months just to design and send everything to Washington to get it precisely made down to a few thousandths. :ROFLMAO:
 

karl

Well-known member
Messages
2,449
Reaction score
717
Location
North east Ohio
"By accepting imperfection, you'll create perfection"

I eyeballed a 5' piece straight , burned it in, cut down to size.

I am waiting on bronze bushings for the tube
 

Attachments

  • 20241106_160548.jpg
    20241106_160548.jpg
    2.4 MB · Views: 3
  • 20241106_160537.jpg
    20241106_160537.jpg
    2.4 MB · Views: 3

karl

Well-known member
Messages
2,449
Reaction score
717
Location
North east Ohio
The gator returns
Sacrificed a 30gal drum
 

Attachments

  • 17309308925033964717392711557899.jpg
    17309308925033964717392711557899.jpg
    1.8 MB · Views: 4
  • 17309309224504667575885191348006.jpg
    17309309224504667575885191348006.jpg
    1.8 MB · Views: 4

karl

Well-known member
Messages
2,449
Reaction score
717
Location
North east Ohio
Thanks!

So a 18mm nibbi round slide fits the factory
Plastic briggs intake perfect. Just need to Dremel the carb tabs and cut down studs mount. Stock briggs with gov removed, will have tc
 

Attachments

  • 20241108_104923.jpg
    20241108_104923.jpg
    1.1 MB · Views: 6
Top