Assuming you're kt100 still has the stock Walbro carb on it, read and follow this article to the letter.
http://nkn.com/nationalkartnews/articles/AnatomyOfWalbro0708.pdf
Stock Yamaha settings say
- Set your popoff 10-12 Lbs
- Low needle - 7/8 turn
- High needle - 3/4 turn
That being said there are no magic one setting fits all, this is especially true with 2 stroke engines.
There are many things factor in on correct settings.
- Track conditions
- what type pipes you're running
- what type clutch you're running
- Altitude
- Humidity
- Barometric pressure
- Temperature
- Fuel/oil ratio
Too rich and it'll bog and run like crap and you'll foul plugs.
Too lean and you'll stick a piston or worse.
You're looking for the fine sweet spot in between.
If anything you'll want it just very slightly rich, when you get Run flat out, wide open throttle, and try to get the motor to peak out at maximum RPM. It will probably sputter at the high end, so turn the H screw in 1/8 of a turn. Try it again. Soon you will find the spot where it screams like a mad chainsaw and sounds like it’s going to fly apart. You don't want it there. Two strokes need excess fuel for internal cooling and they need the oil in the fuel for lubrication. When it's screaming like mad, it's on the ragged edge of being too lean, so open the H screw just a little so it burbles a little instead of screaming. Better safe than sorry.
One thing to remember on these carbs...The H circuit is additive to the L circuit...if you opened (fattened, richened) the L, then you have also richened the high speed operation...so always set your L first, then the H.
NEVER >>> NEVER >>> NEVER go tighter than 3/4 of a turn from seated on the H needle unless you really, really want a brand new engine. If you need to go tighter than 3/4, something's wrong and you need to get it fixed. Gasket leaks are the usual suspects here.