Instead of removing the governor, which creates the circumstances to blow a rod, you could modify it instead to have it allow more RPM. I haven't done this, but in theory it should work. This is also just for a 5hp B&S engine I have, I haven't looked at other engines to see how those governors work.
Basically, in the engine I have, there is a plastic gear connected to the timing gear on the cam shaft. This has two metal parts attached to it and a plastic nub on the shaft (it looks just like the one in solomon's post link). How it works is as the engine spins, it is also spinning the governor. The two metal pieces on it tilt out from centrifigal forces. This causes them to push the plastic nub piece out, which pushes on the lever inside the crank case. This lever is connected to another lever or spring or rod which is connected to the butterfly valve on the carb. When RPM's are sufficient, it will push against these mechanical bits and keep the valve from opening further, thereby limiting the RPM's attained.
Now, to increase RPM's allowed, but not remove it all together, one would only have to increase the force against the plastic nub so that higher RPM's would be needed to spin the metal pieces to create sufficient force against the plastic nub. Adding a spring somewhere that pulls back against the governor would be best. I would not do anything that would have the nub have to move farther, it could pop off and start bouncing around inside the engine.