Idle Adjustment

Status
Not open for further replies.

dave1701

Good for 100,000 Miles
Messages
1,069
Reaction score
1
Location
MICHIGAN
I tried to adjust the idle on my Tecumseh 5hp and I loosened the screw so that the spring was loose, but my clutch was still engaging. The clutch is brand new. Shouldn't it go down until the engine dies? It didn't seem like a very low RPM.
 

jrmints1415

New member
Messages
570
Reaction score
4
Location
Naperville Illinois
is your throttle set up right? pictures would be very helpful of your throttle especially because when you start it it could be going balls out rather then idle. Also try to loosen your idle screw even more!
 

CriticalMass

New member
Messages
239
Reaction score
1
Location
East Bay CA
Check the clutch, my new hillard had one of the clips popped half way off and one plate wasnt sliding all the way back down. Mine would spin at idle too.
 

dave1701

Good for 100,000 Miles
Messages
1,069
Reaction score
1
Location
MICHIGAN
I'll check, but I would be surprised, this is engine is only about a year old.
 

dave1701

Good for 100,000 Miles
Messages
1,069
Reaction score
1
Location
MICHIGAN
Here are some pictures of my kart. See any issues on my throttle linkage? This is my #1 priority on my kart. I want my clutch to last, and I want to be able to let my kart idle without it wearing on the clutch.

NOTE: This clutch is engaged only a tiny bit. When I have the drive wheel up on a stand, it turns. It does not move the kart when it is on the ground.









 

dave1701

Good for 100,000 Miles
Messages
1,069
Reaction score
1
Location
MICHIGAN
oh ok. Thanks. So is it bad for the clutch to let the engine idle for a while. Seems like the slight rubbing would make a ton of heat.
 

dave1701

Good for 100,000 Miles
Messages
1,069
Reaction score
1
Location
MICHIGAN
Thanks for your help. Now I just have to put my seat back on and I can go for a ride.
 
Status
Not open for further replies.
Top