I tried to adjust the idle on my Tecumseh 5hp and I loosened the screw so that the spring was loose, but my clutch was still engaging. The clutch is brand new. Shouldn't it go down until the engine dies? It didn't seem like a very low RPM.
Yes, it should stall. Look for an air leak. Loose carb mounting bolts or a bad gasket could be responsible.Shouldn't it go down until the engine dies? It didn't seem like a very low RPM.
This will happen even when clutch shoes are not engaging at all. Due to friction with clutch bushing or if chain is too tight.When I have the drive wheel up on a stand, it turns.
Should not. My engines can idle all day with no heating of clutches. Fact is, my clutches never get so hot that I can not hold them in my bare hands...even after running for hours.Seems like the slight rubbing would make a ton of heat.