I have a two person kart with a 6.0 hp Tecumseh powersport engine. The engine runs fine. When I start the motor and it sits for a mintue the kart wants to take off on with no one in it and the engine stalls. It makes a whining type noise. If i start the engine with the back wheels off the ground it runs fine, but the back wheels move. I think it is a clutch problem, but was wondering if it can be fixed or do I need to replace it. Thanks for your help.
How to fix a Clutch
- Thread starter reich1
- Start date
- Status
dpaxson
New member
try adjusting the engine to idle lower.
Russ2251
AZUSA:Powered by LAWN-BOY
When was last time bushing was lubricated?
Russ2251
AZUSA:Powered by LAWN-BOY
That's likely your problem. May have been destroyed already. Should be done every couple hours of use.
should i take off the snap ring to oil the bushing? could someone make a youtube video of how to oil a bushing please i'm confused. i've asked a question like this on this forum and nobody has ever come clean imo because i'm a noob. i really want a youtube video. it would help a lot. also i would like to know how to take a snap ring off for a youtube video. would greatly appreciate it and would cause less confusion for me and other noobs.
jr dragster T
New member
I'll make a video in just a sec.
jr dragster T
New member
Sorry uploading is slow expect to have it on in about half a hour.
jr dragster T
New member
Ok here it is. Enjoy! BTW about drilling that hole. It's only used on the "ezy lube" clutch's where there is a grease nipple integrated into the hollow crank bolt (5/16 x 24)
modelengineer
Lord of the noise
Don't use WD-40 to lubricate the clutch, you need to use oil or grease, whatever is specified.
go kart mozart
Member
most clutches use standard sae30
Kenny_McCormic
Kartless....
Gear oil (on the warm clutch)will work even better.
jr dragster T
New member
Yeah gear oil would work too.
I like karts
Rotary Power!
I just use 10w-30 motor oil.
- Status