How should I mount this clutch? 🤔

[Vertrees]

Does it have to fully be on the shaft

 

[G.W]

You see those washers between the wheel and sprocket, get alot more of them

 

[Vertrees]

You see those washers between the wheel and sprocket, get alot more of them

Thanks

 

[Bansil]

Thanks

Make sure the bolts are long enought to have atleast 1-/2 times the diameter engaged

Ie:1/4-20 needs to be screwed in 3/8 of an inch engaged

1/2-13 would need atleast 3/4 of an inch engaged

 

[redflash]

if you just stand a little to the right...........they look lined up perfectly......Thats how we do things here 1

Da redflash

 

[Vertrees]

Make sure the bolts are long enought to have atleast 1-/2 times the diameter engaged

Ie:1/4-20 needs to be screwed in 3/8 of an inch engaged

1/2-13 would need atleast 3/4 of an inch enga

if you just stand a little to the right...........they look lined up perfectly......Thats how we do things here 1

Da redflash

I like the way you think… I’ll follow those steps

 

[ezcome-ezgo]

Is the brake rubbing against the engine case? If some of those nuts were removed could you move the brake over and slide the engine to align the sprockets?

 

[Vertrees]

if you just stand a little to the right...........they look lined up perfectly......Thats how we do things here 1

Da redflash

Is the brake rubbing against the engine case? If some of those nuts were removed could you move the brake over and slide the engine to align the

Is the brake rubbing against the engine case? If some of those nuts were removed could you move the brake over and slide the engine to align the sprockets?

No but it’s mm’s away from touching