This is kind of non go cart related (completely non go cart) but I have an issue and I hope somebody can point me in a direction.
I have a bone stock Honda Gx200 engine and it starts well, I just did a head job on it, new valves etc.
This engine has an electronic throttle. The throttle has 2 speeds 2450 and 3550 RPM. When I set it to 2450 it runs smooth with no load on it. When I kick it up to 3550 (still with no load) it starts to surge and hunt. Not drastic but it is starving for fuel. Spark plug shows lean and putting the choke on about 1/8 to 1/4 will smooth it out. If I put a load on it with the choke open though it gives it a bit more gas and will run smooth.
It has a stock Honda carb with a little motor on it to run the throttle off a computer that senses the engine RPM. It has a 75 main jet and a 45 pilot. I picked up a 78 jet from NR racing, No difference. I also turned the pilot fuel screw out 1/2 turn and that made no difference.
Anyhow, I know you guys are good at carb mods. Any thoughts on how to get it to run smooth at higher RPM's with no load and not sacrifice the way it starts and runs at lower RPM's?
I have a bone stock Honda Gx200 engine and it starts well, I just did a head job on it, new valves etc.
This engine has an electronic throttle. The throttle has 2 speeds 2450 and 3550 RPM. When I set it to 2450 it runs smooth with no load on it. When I kick it up to 3550 (still with no load) it starts to surge and hunt. Not drastic but it is starving for fuel. Spark plug shows lean and putting the choke on about 1/8 to 1/4 will smooth it out. If I put a load on it with the choke open though it gives it a bit more gas and will run smooth.
It has a stock Honda carb with a little motor on it to run the throttle off a computer that senses the engine RPM. It has a 75 main jet and a 45 pilot. I picked up a 78 jet from NR racing, No difference. I also turned the pilot fuel screw out 1/2 turn and that made no difference.
Anyhow, I know you guys are good at carb mods. Any thoughts on how to get it to run smooth at higher RPM's with no load and not sacrifice the way it starts and runs at lower RPM's?