honda gx problem

Status
Not open for further replies.

racingkartbuilder

New member
Messages
5
Reaction score
0
just did racing mods and my engines not revving past 1000 rpm and idling at 800 have no clue what's going on the kart moves slow and then shuts off please help.
 

mckutzy

Well-known member
Messages
8,353
Reaction score
113
Location
bc, canada
Hello and welcome,
What exactly is the motor you have, what mods/parts did you install, what are you using to measuring the rpm's from...
Also how abouts some pics of what it is on...
 

racingkartbuilder

New member
Messages
5
Reaction score
0
its a gx200 and I added a billet flywheel, high flow air filter,18 pound springs, billet cam, billet connecting rod, and fuel pump with a top plate also a header pipe, using it on a racing kart and to measure rpm I'm using a quartz tachometer
 

mckutzy

Well-known member
Messages
8,353
Reaction score
113
Location
bc, canada
I see you have a typical kit... Which is fairly good, however usually with the filter and header you will need to re-jet the carb...
That wouldn't really be the cause of low rpm...

What carb do you have. It might not be sealed against the block properly, a gasket or the insulator plate is cracked(if it is the OEM carb)?...

Is the gov in or removed?
How is the throttle cable connected to the carb, original linkages and throttle plate or direct to the carb?...

Check throttle cable and all connections to the pedals.
 

Kleyny

New member
Messages
140
Reaction score
4
Location
Brisbane Australia
Have you opened the engine at all?
Are you sure you're getting full range of movement in the carb throttle.

Can you make a video of it "running" including start up?
 

cavfire

Member
Messages
110
Reaction score
1
Location
auburn, georgia
From the sound of it all parts were added at once which can be nerve racking when things don't go as planned. Air filter and pipe alone would require the jetting to be looked at, which isn't mentioned or what the plug looks like.

You said you changed the flywheel, if it's an ARC flywheel the coil gap is different than stock. Somewhere in the .030" range and definitely worth checking.

Fuel pumps can be tricky due to flooding from overriding the float needle. Even if it isn't smoking from being rich, you should be able to smell the exhaust being overly rich. I'm tee'd off back to the tank with an inline shutoff about half way to overcome this, and I think Flyinhillbilly posted another method that's slicker than greased owl sh!t on a piece of ice.

Already mentioned are the timing dots lining up and the throttle linkage, and both a very plausible.
 

Kleyny

New member
Messages
140
Reaction score
4
Location
Brisbane Australia
From the sound of it all parts were added at once which can be nerve racking when things don't go as planned. Air filter and pipe alone would require the jetting to be looked at, which isn't mentioned or what the plug looks like.

You said you changed the flywheel, if it's an ARC flywheel the coil gap is different than stock. Somewhere in the .030" range and definitely worth checking.

Fuel pumps can be tricky due to flooding from overriding the float needle. Even if it isn't smoking from being rich, you should be able to smell the exhaust being overly rich. I'm tee'd off back to the tank with an inline shutoff about half way to overcome this, and I think Flyinhillbilly posted another method that's slicker than greased owl sh!t on a piece of ice.

Already mentioned are the timing dots lining up and the throttle linkage, and both a very plausible.
What is flyinhillbillys way I can't find it?
Converting mine to fuel pump shortly would like to know a few different methods incase mine floods
Thanks
 
Status
Not open for further replies.
Top