Honda clone timing question/not starting

Status
Not open for further replies.

Flyinhillbilly

The great cornholio
Messages
2,468
Reaction score
132
Location
North West Arkansas
You may have set the lash on the exhaust stroke, I know the dots on a sbc are on the exhaust stroke when they line up. Just turn it over like PB said while watching the rockers. Both valves should be closed on the up stroke and the following down stroke as long as it's at TDC on the compression stroke.
 

screwloose

New member
Messages
20
Reaction score
0
conclusion

I got it to start last night!:wai:
I got so frustrated on saturday, I do what I always do. Tear it apart completely and start over.
Piston and piston rings were fine, head gasket head was fine, crank, con rod, bearings ect all fine
After an inspection of the coil it was a little off on one side, maybe enough to make a spark shakey but no completely eradicate it. In any case it's gaped properly now. Could have added to the problem.
Hillbilly and others were dead right though, I was lashing the valves on the exhaust stroke.
Thanks for the help guys. This forum is great!
 

landuse

Moderator
Staff member
Messages
18,803
Reaction score
612
Location
Pietermaritzburg, South Africa
I got it to start last night!:wai:
I got so frustrated on saturday, I do what I always do. Tear it apart completely and start over.
Piston and piston rings were fine, head gasket head was fine, crank, con rod, bearings ect all fine
After an inspection of the coil it was a little off on one side, maybe enough to make a spark shakey but no completely eradicate it. In any case it's gaped properly now. Could have added to the problem.
Hillbilly and others were dead right though, I was lashing the valves on the exhaust stroke.
Thanks for the help guys. This forum is great!

I'm glad you got it sorted out
 
Status
Not open for further replies.
Top