Honda Clone takes several pulls to start

Status
Not open for further replies.

ghostdog

New member
Messages
139
Reaction score
0
I have an older motor from a kart from a guys on craigslist. I know, it could be in any condition. Well by the looks of it, is in pretty good condition.

It's a Harbor Freight 6.5hp clone, specifically the older Blue clone that has Greyhound as the manufacturer.

The problem I am experiencing is it can take any where from 5-15 pulls to get it going. Once it is going it runs like a top, idles great and I have zero complaints.

It has a brand new ebay carburetor, new muffler, fresh gas, new plug gapped at 0.030 (NGK BPR6ES), K&N style air filter and new gas tank. Basically aside from a new motor I am not sure what else it could be.

I have a new recoil/rope assembly I could install if that might help.

Do you think I should try a smaller plug gap?
Maybe try adjusting the idle to a much higher speed to see if that might help?

There is a small screw on the side of the carburetor, some sort of adjust I guess.

From what I've read it could be the gap between the flywheel and coil that should be about the thickness of an index card. Is this easy to adjust/check?

I will entertain all reasonable things to try.
 

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
got the stock parts? put a stock airbox and muffler on and see if it changes anything. next id like to know, is the governor gone? if so it can take a tiny bit of throttle to start her up
 

ghostdog

New member
Messages
139
Reaction score
0
The muffler is like this.



Air filter



Governor is still intact.

I have a stock exhaust I could try but it was like this before the longer pipe w/ briggs exhaust.
 

souperman000

New member
Messages
2,466
Reaction score
11
Location
Westlake Village, CA
There is a small screw on the side of the carburetor, some sort of adjust I guess.

This screw is either the idle adjustment screw or the fuel mixture screw. if the engine idles fine then the idle screw shouldnt need to be adjusted, but it is worth a try i guess.

The little screw that is in the flywheel assembly might be sheared, take it out and look.

IMO, try the new assemply you have and see if it works. If it does than use that one while you work out the kinks with the current one. Then you will have an extra!

Anyways, good Luck!
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
Ghostdog, that milled muffler bracket is a nice touch!
I would adjust the black idle screw until the clutch starts to engage a little, then back off a bit.
 

ghostdog

New member
Messages
139
Reaction score
0
Unfortunately that isn't mine. Just a reference photo hotrodminibike.com , I am just using an OMB muffler bracket.
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
That's cool, I am just kidding about :)
I need to get a nice exhaust like that for my clone, I only have a wiener pipe :(
Have you tried the idle thing yet?
Edit: oh and I think superman means the flywheel key could be sheared. Possible, but I expect it would try and bite your hand off and run a little pooey.
 

ghostdog

New member
Messages
139
Reaction score
0
I adjust the idle screw two turns and it turned on after 2 pulls. How easy is that. Sorry guys.
 
Status
Not open for further replies.
Top