Denny
Canned Monster
Also thatās what files are for.
Here we go again š¤¦*āļø
- Thread starter Miky
- Start date
ezcome-ezgo
G'me sumthin to write on
Sure if you're a caveman or something.
Denny
Canned Monster
Itās so easy even a cave man can do it!!!
Bought this gokart for my project, I thought I'd disassemble it for parts for my original kart what was I meaning to do but I think I will do this one. It is in way better condition. Anyone knows what chassi is this?
Attachments
-
20221106_150243.jpg -
20221106_150253.jpg -
20221106_150353.jpg -
20221106_150401.jpg -
20221106_150407.jpg -
20221106_150414.jpg -
20221106_150420.jpg
madprofessor
"Loose Cannon Creations"
Kart in pics above really has some distance between the wheels and the axle bearings. More than I'd be comfortable with.
Good observation, I got the gokart so, I'll se can I move it a bit inside, thanks
Can someone help me out? I've got 14 tooth centrifugal clutch, 6:1 gives me 84 tooth sprocket for the drive shaft. Chain size is s 420. I can't find a sprocket. I'm from Germany, something in Europe would be nice. And tire height is 22 cm
Denny
Canned Monster
Your going to need a jackshaft. Iām in the USA so unfortunately not much help to you.
madprofessor
"Loose Cannon Creations"
Makes the gear ratios nearly endless. Easily available small sprockets, I like a heavier 3/4" shaft, with a smaller one from engine, larger one to axle.
So guys I decided to build a jackshaft, I have jackshaft from last project with 20 tooth and 30 tooth sprockets. Because I'm bound with centrifugal clutch which is 14 tooth and 420 chain I'll go from clutch with 420 chain and sprockets and on opposite side of the jackshaft I'll go with 35 chain size. Will that work, in theory it should work.
Attachments
-
Screenshot_20221120-101144_Chrome.jpg
Denny
Canned Monster
Yes it will work, good luck trying to figure out the ratio though. You might need a math professor.