hemi heads or domed pistons?

Status
Not open for further replies.

jr dragster T

New member
Messages
3,966
Reaction score
10
Location
Cold place
I have seen those COX RC plane motors but I dont think a 1/4" - 3/8" slot is going to exhaust a fairly large 200 cc + 2 stroke. The exhaust port on one of my 440 cylinders is like 2" around. Plus a cox style port would be extremely crude.
 

mike75925

thinker and tinkerer
Messages
1,753
Reaction score
4
Location
Alto, tx
probably not, ;) but you start small and build up. isn't that what we do here? taking measurements off of a good race 2stroke in relation to bore should get you close to the same output ratio. i'm thinking you would need alot more fin. being that it fires on every rev. schnuler(i don't think i spelled that right) is the ports to push the fuel from the case to the top of the piston, right? wouldn't need those if you had a sealed crank case.
 

mike75925

thinker and tinkerer
Messages
1,753
Reaction score
4
Location
Alto, tx
back on track, i was just reading up on hi-po motors. the 3, 4, 5, 6 and 8 valve types. they run hemi style heads. here's a nice one http://en.wikipedia.org/wiki/File:Ovalpiston.jpg

crazy pistons though. i could have sworn at one point i saw a bike that had triangle pistons. boy would i hate ringing them. maybe they'd be like a rotary's apex seals?
 

freakboy

the names 'mater
Messages
3,961
Reaction score
2
Location
hick town
:huh:ummm......why not just add bigger valves so more cf goes in without having to have a cam wit a billion lobes on it and have a billion lifters and a billion valves to go wrong?
 

mike75925

thinker and tinkerer
Messages
1,753
Reaction score
4
Location
Alto, tx
bigger valves, supposedly do not do as well as multivalve, more than two. what i read anyway. the more valves, the better they breath, and something about keeping the valve train geometry correct. no lifters, ohc, or rather dohc.
 

mike75925

thinker and tinkerer
Messages
1,753
Reaction score
4
Location
Alto, tx
thats what they are saying. they also said (article on multivalves on wiki) that forked rockers have been around since, like 1912? so why haven't we upgraded yet? hunh? kidding
 

oscaryu1

New member
Messages
2,767
Reaction score
7
May be more efficient, you you'll suck up alot of free power from the weight of the springs.
 

mike75925

thinker and tinkerer
Messages
1,753
Reaction score
4
Location
Alto, tx
everything is a compromise in an engine. but when you want to go faster than avg, seems multi is the way to go. 04 r1 has 76lbft or 103Nm, 170hp or 126kilowatts. 998cc 5valve per and fuel injected. i know some people don't put much stock in movies/videogames, but some jap company ran an extra smaller pipe and muffler off of the main to increase breatheability. maybe putting some holes in your exhaust pipe to do a ram air effect will help breatheability. i slash cut my straight pipe mainly because i thought it looked cool, but hopefully it will help to scavenge the hot gases from my engine
 
Status
Not open for further replies.
Top