I have connected a twist throttle cable to what I thought was the throttle butterfly on the carby. But the engine does not want to run using that caonnection.
Removed the spring and wire that goes to the governor vane. Then connected my throttle cable to that part where the governor arm went to.
There is also another lever below the one I connected too.
The engine starts with the choke fully out, and there is no response when I twist the throttle, the engine just dies.
So I can start the engine and rev the engine if I hold onto the choke and use it like a throttle... which is strange.
Then I thought that other lever might be the throttle but it too has no effect on the engine.
I am thinking that the govenor spring and arm should have stayed on the carby???? Unfortuanatley I cut that control arm wire to remove it as I was thinking that I do not need the govenor.
What do I do now???
Why does the engine not rev like I want it too?
Does it need to be a combination of both the two levers connected?
Removed the spring and wire that goes to the governor vane. Then connected my throttle cable to that part where the governor arm went to.
There is also another lever below the one I connected too.
The engine starts with the choke fully out, and there is no response when I twist the throttle, the engine just dies.
So I can start the engine and rev the engine if I hold onto the choke and use it like a throttle... which is strange.
Then I thought that other lever might be the throttle but it too has no effect on the engine.
I am thinking that the govenor spring and arm should have stayed on the carby???? Unfortuanatley I cut that control arm wire to remove it as I was thinking that I do not need the govenor.
What do I do now???
Why does the engine not rev like I want it too?
Does it need to be a combination of both the two levers connected?