Help Kart literally running away lol

Status
Not open for further replies.

Racer2874

New member
Messages
9
Reaction score
1
Just changed Carb. Now bike wants to take off like a bat out of **** when I start her. Adjusted idle speed. Is tightening the idle make it more sensitive? Or are there any other things that I need to be looking at?
 

Hellion

Staff Murderator
Messages
9,448
Reaction score
4,378
Sounds like the higher idle speed is engaging the clutch, if ever so slightly. Is it a kart or a bike? :huh:
 

Racer2874

New member
Messages
9
Reaction score
1
It's a kart. 212cc so should I tighten the idle or loosen it? If its engaging the clutch then it's really engaging lol cause it wants to go when started on choke but when i open it up to run just ever so slightly then it really wants to pin the throttle down and take off hard

---------- Post added at 09:56 AM ---------- Previous post was at 09:54 AM ----------

There is a lever that is attached to the other side of my carb that is super tight. It looks like it's attached to my govenor?? I'm wondering now if that's the issue
 

mckutzy

Well-known member
Messages
8,353
Reaction score
113
Location
bc, canada
Lets see some pics...
Have you checked the throttle cable to make sure it's not pulling slightly.
I had this on a brand new engine, turned out throttle cable was pulling the throttle open a bit causing it to runaway.
 

Hellion

Staff Murderator
Messages
9,448
Reaction score
4,378
You need a little slack in your throttle cable, it sounds like. It's not 'tightening the idle' as you say but it's all in the cable, tight or loose. Loosen it and report back.
 

Racer2874

New member
Messages
9
Reaction score
1
Yes I checked gaskets and isolator are on correctly. I think its the throttle cable pulling the gate on the back of the carb open causing it too run off. I'll post pics son if I don't get it. Thank you all.

---------- Post added at 01:33 PM ---------- Previous post was at 01:22 PM ----------

It could actually be the return spring on the throttle. It's super tight just leaving the back butterfly valve on the carb wide open. Sound about right to anyone?
 

Poboy kartman

Senior Moments Member
Messages
12,461
Reaction score
73
Location
White Settlement Texas
Yes I checked gaskets and isolator are on correctly. I think its the throttle cable pulling the gate on the back of the carb open causing it too run off. I'll post pics son if I don't get it. Thank you all.

---------- Post added at 01:33 PM ---------- Previous post was at 01:22 PM ----------

It could actually be the return spring on the throttle. It's super tight just leaving the back butterfly valve on the carb wide open. Sound about right to anyone?

No....that would CLOSE it!
 

JollyKarter

New member
Messages
97
Reaction score
1
Location
Texas
Is it idling high or running wide open? I am wondering if you have something messed up with the governor/throttle linkage
 

Racer2874

New member
Messages
9
Reaction score
1
Bummer. I believe it's gotta be the govenor throttle linkage.

---------- Post added at 04:59 PM ---------- Previous post was at 04:59 PM ----------

It's running wide open not idling high btw.

---------- Post added at 05:55 PM ---------- Previous post was at 04:59 PM ----------

It was the throttle linkage to the back butterfly valve. Had it slightly open. Thank you to everyone on here once again always a big help!
 
Status
Not open for further replies.
Top