Harbor freight engine swap

[bob58o]

Update!! Runs great. Doing spindles this week. Only problem left is the engine kill switch. It's a single wire and I grounded it like it was on the other engine but it doesn't work. I even grounded it with the engine kill switch ground and nothing. What am I doing wrong?

I usually unplug the wire coming from the "gold" box going to the "bolt" that leads into the crankcase for the low oil sensor.

The wire coming from the gold box (the low oil wire I unplug) is what I use for the kill switch. I usually use two wire switches and run the other wire back to where the ignition is ground, but the single wire should just connect to the same wire coming from the gold box and then ground to where ever you mount it on the kart.

There are a few ways to wire the kill switch.

 

[Avery]

Also, how much fabrication to put 2 bucket seats in place of the bench seat ?

 

[bob58o]

I feel weird asking for a picture of your seat. With some tape measure measurements.

 

[Avery]

Sorry, I was out of town for a few days. I'll send pics and measurements later