pinoyclass
New member
- Messages
- 10
- Reaction score
- 0
I currently just purchased a frame and installed a seperate engine honda gx340 11hp. I have it set up with a comet 40 series torque converter on a jackshaft with 10T sprocket going to a 60T sprocket. I test drove it this weekend and felt pretty good compared to a 6.5hp honda clone with a similar 30 series setup.
Anyway my question is I hooked up the throttle cable to the lever but after riding it around I felt the engine had more potention. I put the rear end on blocks and reved the engine by hand with the lever. I then reved the engine by the linkage directly connected to the carb and wow what a difference. Is this opening it up to the full 3600rpm or am I essentially bypassing the governer by reving the linkage connected to the carb?
Karl
Anyway my question is I hooked up the throttle cable to the lever but after riding it around I felt the engine had more potention. I put the rear end on blocks and reved the engine by hand with the lever. I then reved the engine by the linkage directly connected to the carb and wow what a difference. Is this opening it up to the full 3600rpm or am I essentially bypassing the governer by reving the linkage connected to the carb?
Karl