r_chez_08
Should be in the shop...
Ok well I was going to remove my gx200 clone crankshaft to do a repair (havent decided how I am going to fix it yet, but I know it will involve a crank removal.)
Anyway, is there anything I should know? What I was planning to do:
1.Remove engine from kart
2.Remove recoil shroud
3.Drain oil
4.Remove side cover and camshaft
5.Take out spark plug and fill the cylinder with clean rope
6.Partially undo flywheel nut, and tap it with a happer with a few threads on to remove flywheel.
7.Undo con rod bolts, then take out crankshaft
Is this ok? For re assembly I was going to do the same but in reverse. I understand it is a good idea to torque the bolts to correct spec, and i was going to buy/borrow a torque wrench.
Do I need to reset timing on the rockers or do anything else? If so how?
Thanks
Rob
Anyway, is there anything I should know? What I was planning to do:
1.Remove engine from kart
2.Remove recoil shroud
3.Drain oil
4.Remove side cover and camshaft
5.Take out spark plug and fill the cylinder with clean rope
6.Partially undo flywheel nut, and tap it with a happer with a few threads on to remove flywheel.
7.Undo con rod bolts, then take out crankshaft
Is this ok? For re assembly I was going to do the same but in reverse. I understand it is a good idea to torque the bolts to correct spec, and i was going to buy/borrow a torque wrench.
Do I need to reset timing on the rockers or do anything else? If so how?
Thanks
Rob