GX200/212 jetting

Status
Not open for further replies.

J.S.@SMS

Road Hazard
Messages
866
Reaction score
18
Location
Weeki Wachee Fl.
Does anyone know if a .055 jet is big enough to run isopropyl alcohol?
If not I also have a .0595 drill bit, and can get my hands on .056, .057, or a .058 jet, if those will work.
 

65ShelbyClone

Active member
Messages
717
Reaction score
249
Location
SoCal
I don't think anyone is going to know that.

If you can find what the difference in stoichiometric air-fuel ratios is between gasoline and iso, then you can figure out about how much more jet area is needed as a starting point. That assumes the jetting was correct to begin with and that the iso is 99%+. It's going to be way off if you're using drugstore 91%.
 

J.S.@SMS

Road Hazard
Messages
866
Reaction score
18
Location
Weeki Wachee Fl.
Well, not quite drugstore 91%. You see, when you put that in a freezer for a day or two, the water, which freezes at 32 F, will freeze, whereas the isopropyl alcohol, which freezes at -128 F, remains a liquid. That'll result in a pretty low amount of remaining water.

And that's the thing though, I cant find anything even relating to the afr of isopropyl, besides an old thread in a Buick forum, of all places. I was thinking that another option might be getting 3 jets, tuning one where it will barely run lean, and tuning one where it'll barely run rich, and tuning the third in between. If that'll work.
 

65ShelbyClone

Active member
Messages
717
Reaction score
249
Location
SoCal
Well, not quite drugstore 91%. You see, when you put that in a freezer for a day or two, the water, which freezes at 32 F, will freeze, whereas the isopropyl alcohol, which freezes at -128 F, remains a liquid. That'll result in a pretty low amount of remaining water.

Now I'm curious why you want to burn isopropyl alcohol. It only has an octane that's in the mid-90s.

I've done it before with pure iso and my advice is to do it in a well ventilated area. It's pretty noxious when the mixture is rich.

And that's the thing though, I cant find anything even relating to the afr of isopropyl, besides an old thread in a Buick forum, of all places.

I found that and went through the chemical equation myself and got the same numbers.
 

JTSpeedDemon

2019 Build Off Winner!
Messages
4,026
Reaction score
164
Location
Texas
Are you trying to burn isopropyl for it's availability?
Like '65 said, it doesn't have a very high octane rating. Ethanol, as much as I hate it, has a higher octane rating.
You'd probably be better off with methanol, since there's at least a community that does that.
 

J.S.@SMS

Road Hazard
Messages
866
Reaction score
18
Location
Weeki Wachee Fl.
Yes, methanol or ethanol would be better, but I would like to be familiar with isopropyl tuning, in case a certain bill is brought up again and passes, which would completely get rid of all gasoline fuels, and the internal combustion engine, by 2030. But, I can almost guarantee that they wont get rid of medical products like isopropyl alcohol. Even though the likelihood of that bill passing is extremely slim.
 

itsid

Moderator
Staff member
Messages
11,563
Reaction score
260
Location
Ruhrpott [Germany]
Well, not quite drugstore 91%. You see, when you put that in a freezer for a day or two, the water, which freezes at 32 F, will freeze, whereas the isopropyl alcohol, which freezes at -128 F, remains a liquid. That'll result in a pretty low amount of remaining water.
Oh how wrong you are....

isopropyl alcohol (isopropanol) is a perfect antifreeze
and used as such in cars cooling systems around the globe,
it essentially encapsulates water molecules just as easily as ethanol does,
and with that it prevents it from freezing at whatever arbiturary scale of Frankfurters you use

91% of IPA wouldn't want to seperate from water down to -80°C or such
(small hint: 0°C water freezes.. +100°C water boils perfectly linear scale [unlike fartenburgers])

'sid
 
Status
Not open for further replies.
Top