HELLSUNICORN
New member
- Messages
- 8
- Reaction score
- 0
I purchased a GTC 30 series with a 1 inch driver a couple of years ago. I have finally gotten around to installing it. I am installing it on a brand new 8 hp Harbor freight engine. The problem I have is that once the engine is started the belt does not slip at all and the cart wants to go forward. If I have the cart on the hoist the torque convertor works correctly with the exception that it will not allow the belt to slip at idle.
I have adjusted the idle down as far as it will go. It is not an idle issue. It seems to me like the belt is to short. The belt is the correct number they list on the website and it is the belt that came in the kit. The belt is very tight once it is installed. I have the belt facing the correct way and the pulleys are aligned. I also have the shaft of the engine centered in the hole of the back plate..
At this point I'm stumped. Either the backplate is machined in correctly, the belt has shrunk or it was manufactured wrong.
Any ideas would be great. I would like to have this running this weekend for my daughters birthday. Thanks in advance..
I have adjusted the idle down as far as it will go. It is not an idle issue. It seems to me like the belt is to short. The belt is the correct number they list on the website and it is the belt that came in the kit. The belt is very tight once it is installed. I have the belt facing the correct way and the pulleys are aligned. I also have the shaft of the engine centered in the hole of the back plate..
At this point I'm stumped. Either the backplate is machined in correctly, the belt has shrunk or it was manufactured wrong.
Any ideas would be great. I would like to have this running this weekend for my daughters birthday. Thanks in advance..