Gas problem

Status
Not open for further replies.

chancer

ɔ ɥ ɐ u ɔ ǝ ɹ
Messages
9,358
Reaction score
97
Location
COMFORT, TEXAS
I think you are on the right track, checking the needle. Also a good habit is to turn off the gas when not in use. This should not b necesary but it will help.
 

mckutzy

Well-known member
Messages
8,353
Reaction score
113
Location
bc, canada
Of the honda's and clones, they all have a problem with gas drain back. Ive done 2 oil changes from forgetting to close the petcock....
 

OzFab

Well-known member
Messages
15,615
Reaction score
76
Location
Warwick Qld, Australia
In the pic attached, see the bolt head the arrow is pointing to? That's a crank case drain plug...

The issue is definitely a needle/seat/float issue, it could be as simple as a float adjustment (most likely scenario) or as serious as the needle/seat need replacing; are you familiar with the procedure for checking the float level?
 

Attachments

  • image_25232.jpg
    image_25232.jpg
    191.3 KB · Views: 5

Holybeen

Member
Messages
173
Reaction score
3
Location
Hattiesburg mississippi
Pic didn't work lol. I know how to drain it just didn't know if I should try to flush it or not. I upgraded the emulsion tube and new needle a few weeks ago. Sadly, I don't know how to check the float level though.
 

chancer

ɔ ɥ ɐ u ɔ ǝ ɹ
Messages
9,358
Reaction score
97
Location
COMFORT, TEXAS
I think if you just drain it you will be fine. Maybe leave the oil filler and drain open for a little while, the gas should evaporate out. JMO.
 

Daniel Sheffield

New member
Messages
90
Reaction score
0
Location
San Antonio, tx
Had this happens once.I did it the hard way.completely disassembled the engine and cleaned with carb cleaner and degreaser. Didn't want to be to careful, but probably unnecessary.
 

mckutzy

Well-known member
Messages
8,353
Reaction score
113
Location
bc, canada
I just put fresh oil in..
If drained thoroughly it'll be fine...

In fact when I first found out I had a gas leak... It was leaking from the oil bung that wasnt tightened properly... I had ran a almost full crankcase of oil/gas for many hours...
 

OzFab

Well-known member
Messages
15,615
Reaction score
76
Location
Warwick Qld, Australia
Sadly, I don't know how to check the float level though.

With the fuel tap off, remove the fuel bowl from the bottom of the carb; the float will be hanging; gently lift up the float until you feel resistance; adjusted correctly, it should sit level or slightly down from the pivot pin...

If the float sits too high, it needs to be adjusted; this is done by gently bending the small metal flap which connects the needle (see pic); bending the flap up makes the float sit lower, bending down makes it sit higher...

Once you are happy with the position/angle of the float, hold the float up & open the fuel tap; if fuel runs out, apply a little more upward pressure to the float; if that still doesn't stop the flow, your new needle isn't seating correctly...
 

Attachments

  • Carb float.jpeg
    Carb float.jpeg
    22.8 KB · Views: 1
Status
Not open for further replies.
Top