Sadly, I don't know how to check the float level though.
With the fuel tap off, remove the fuel bowl from the bottom of the carb; the float will be hanging; gently lift up the float until you feel resistance; adjusted correctly, it
should sit level or slightly down from the pivot pin...
If the float sits too high, it needs to be adjusted; this is done by gently bending the small metal flap which connects the needle (see pic); bending the flap up makes the float sit lower, bending down makes it sit higher...
Once you are happy with the position/angle of the float, hold the float up & open the fuel tap; if fuel runs out, apply a little more upward pressure to the float; if that still doesn't stop the flow, your new needle isn't seating correctly...