G100 carb problem

Status
Not open for further replies.

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
Okay, I know it is a carb problem cos I put my gx200 clone carb on and it ran fine, but what the motor does when you rev it is rev up, then go down then up again, then down etc.
I have cleaned the main jet and emulsion tube, but I have managed to snap one of the little plastic brackets that the float pivots on. Could this be the cause of my problem? If so can I replace the bracket? Or shall I get a 80cc motorbike carb instead for £10?
Rob
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Yeah, I'd say it's a pretty fair bet that the engine's erratic behavior is due to the cockeyed float...

I have no idea if you can find a replacement, I don't think it's part of the normal carb rebuild kit. I think I would shop for another carb.
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
**** :/ i had another carb body and i dropped it and it broke the same bracket :( i might try and fabricate a new one, but if not, will this carb mount ok?
Rob
Edit: wow! D amn is *'d out!
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
Ok, thanks. I can fab an adapter, but I will first try and make a bracket for the float somehow.
Does that carb look of an ok size?
Rob
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
My vote's on the float, only because you said it's behaving erratically. I picture the float sitting cocked on a bit of an angle because one side of the hinge bracket is broken. So, with it unable to pivot freely, it won't properly regulate the available fuel.
 
Status
Not open for further replies.
Top