Front sprocket

Status
Not open for further replies.

blakebammeyers

New member
Messages
2
Reaction score
0
Location
Illinois
I have a predator 212 with a knockoff comet TAV2-30 series torque converter. The axle on my go kart has a 428 chain rear sprocket, and my torque converter only came with a #35 and #41 chain front sprocket. I have a brand new heavy duty 428 chain that fits my rear sprocket, but not my front sprocket obviously. The driveshaft on my torque converter is 5/8", and I'm pretty sure 16mm is pretty close to it. I need to find a 428 chain front sprocket with a 5/8" or 16mm bore, but I've looked on Google and eBay but still nothing. I can't find it anywhere. The rear sprocket on my axle definitely is not going anywhere. It's rusted to the axle which I can't afford to replace. Is there a front sprocket with a similar chain size I could use that has a 5/8" or 16mm bore? I appreciate the help.
 

bob58o

SuckSqueezeBangBlow
Messages
9,646
Reaction score
1,866
Location
Chicago-town USA
I have a predator 212 with a knockoff comet TAV2-30 series torque converter. The axle on my go kart has a 428 chain rear sprocket, and my torque converter only came with a #35 and #41 chain front sprocket. I have a brand new heavy duty 428 chain that fits my rear sprocket, but not my front sprocket obviously. The driveshaft on my torque converter is 5/8", and I'm pretty sure 16mm is pretty close to it. I need to find a 428 chain front sprocket with a 5/8" or 16mm bore, but I've looked on Google and eBay but still nothing. I can't find it anywhere. The rear sprocket on my axle definitely is not going anywhere. It's rusted to the axle which I can't afford to replace. Is there a front sprocket with a similar chain size I could use that has a 5/8" or 16mm bore? I appreciate the help.

I think 428 is similar to #41. 428 chain should work on a #41 sprocket I THINK.
Read this thread...
http://www.diygokarts.com/vb/showthread.php?t=10135
Roller width is a little wider on the 428 (5/16" vs 1/4")
 

itsid

Moderator
Staff member
Messages
11,563
Reaction score
261
Location
Ruhrpott [Germany]
I haven't seen a 428 C-Type sprocket yet...

And frankly, since that's a fairly common gy6 size I have the strong feeling,
that you converted a gy6 kart to a industrial engine kart and that just won't work at all...

The rear sprocket on most gy6 powered karts I've seen is ridiculously small (the engine is geared down internally by a good amount)
so you have maybe a 48T sprocket.. and that will not work anyways!

Buy a #40 chain swap out the sprocket to something like 70 Teeth #40 (yes.... I think you'd need that many teeth) and then use the 10T #41 the TC came with.

'sid
 

Poboy kartman

Senior Moments Member
Messages
12,461
Reaction score
73
Location
White Settlement Texas
And...before you say it...it doesn't really matter that you can get the old sprocket off!

You just don't have a choice...you could possibly just scab the new sprocket onto the old one ....(think about it!)....the alignment would still be near perfect...the smaller sprocket would act as a stabilizer for the new one...
 
Status
Not open for further replies.
Top