sideways
Unfinished projects king.
you think a 5hp briggs dipper would work?
well mines a taper shaft, pulley is rusted on good, and it has a slight wobble.
EDIT: also it would make the dipstick horisontal and it would definately leak out the worn seal.
No idea about the Briggs dipper, I haven't taken one apart for years. I doubt it would fit because the one in this has to lean forward quite a lot. It's worth a try if you've got a spare dipper.
Yep, I moved the dipstick so it was upright.
I just used a bit of pipe, easy as and didn't leak. Took ages to fill it up with oil though.
Thanks
Hayden